Journal of Craniovertebral Junction and Spine

ORIGINAL ARTICLE
Year
: 2017  |  Volume : 8  |  Issue : 2  |  Page : 97--102

Atlas instrumentation guided by the medial edge of the posterior arch: An anatomic and radiologic study


Amro F Al-Habib1, Abdulkarim Al-Rabie1, Sami Aleissa2, Abdulrahman Albakr1, Abdulaziz Abobotain1 
1 Department of Surgery, Division of Neurosurgery, College of Medicine, King Saud University, Riyadh, Saudi Arabia
2 Department of Orthopedics, King Saud Bin Abdulaziz University for Health Sciences, Riyadh, Saudi Arabia

Correspondence Address:
Amro F Al-Habib
Department of Surgery, Division of Neurosurgery, College of Medicine, King Saud University, Post Box No: 59220, Riyadh 11525
Saudi Arabia

Study Design: This was an interventional human cadaver study and radiological study. Objectives: Atlas instrumentation is frequently involved in fusion procedures involving the craniocervical junction area. Identification of the entry point at the center of atlas lateral mass (ALM) is challenging because of its rounded posterior surface and the surrounding venous plexus. This report examines using the medial edge of atlas posterior arch (MEC1) as a fixed and reliable anatomic reference to guide the entry point of ALM screws. Methods: Fifty, normal, cervical spine computed tomography studies were reviewed. ALM screw trajectories were planned at one point along MEC1 and another point 2 mm lateral to MEC1. Free-hand ALM instrumentation was performed in ten fresh human cadavers using the 2 mm entry point, with a sagittal trajectory parallel to atlas inferior arch (IAC1); three-dimensional imaging was then performed to confirm instrumentation accuracy. Results: The average ALM diameter was 12.35 mm. Inserting a screw using the entry point 2 mm lateral to MEC1 was closer to ALM midpoint than using the entry point along MEC1 (P < 0.0001). Twenty ALM screws were successfully inserted in the ten cadavers. No encroachments into the spinal canal or foramen transversarium occurred. However, two screws were superiorly directed and violated the occipitocervical joint; they were not parallel to IAC1. Conclusion: MEC1 provides a fixed and reliable landmark for ALM instrumentation. An entry point 2 mm point lateral to MEC1 is close to ALM midpoint. IAC1 also provides a guide for the sagittal trajectory. Attention to anatomic landmarks may help reduce complications associated with atlas instrumentation but should be verified in future clinical studies.


How to cite this article:
Al-Habib AF, Al-Rabie A, Aleissa S, Albakr A, Abobotain A. Atlas instrumentation guided by the medial edge of the posterior arch: An anatomic and radiologic study.J Craniovert Jun Spine 2017;8:97-102


How to cite this URL:
Al-Habib AF, Al-Rabie A, Aleissa S, Albakr A, Abobotain A. Atlas instrumentation guided by the medial edge of the posterior arch: An anatomic and radiologic study. J Craniovert Jun Spine [serial online] 2017 [cited 2022 Oct 6 ];8:97-102
Available from: https://www.jcvjs.com/article.asp?issn=0974-8237;year=2017;volume=8;issue=2;spage=97;epage=102;aulast=Al-Habib;type=0